AMX-Series Product Assembly Guide

Note: if your casing is socket welded, skip this step Parts check Check the O-Rings to make sure there are no scratches or visible damage Make sure the O-Ring surfaces are clean and smooth Check and m...

Parts check Check the Front Casing to make sure there is no visible damage or debris Check the Front Shaft Support to make sure it is not deformed or damaged Check the Pump Shaft to make sure it is cl...

Parts check Check the legs of the Buffer to make sure there is no deformation or damages Check to make sure the Thrust Ring is secured to the Buffer by welding (IPQC 1) Make sure there are no damages ...

Parts check Make sure the Wear Ring is welded to the Impeller (IPQC 1) Make sure the Wear Ring is clean and not damaged (IPQC 2, IPQC 3) Make sure the Bearing is clean and not damaged Installing the I...

Parts check Check the O-Ring / Gasket to make sure there are no scratches or visible damage Make sure the O-Ring / Gasket surfaces are clean and smooth Check and make sure the seal surfaces are clean ...

Note: For the AMX-220/221/440/441 models, the Bracket must be assembled to the Motor first. Click here to jump to the instructions. Once the Bracket is installed, skip to Step 3 below to continue with...

Parts check For plastic Bracket and Base Check the exterior for any cracks or damage Check the threads of the embedded nuts in the Bracket For cast iron Bracket and stainless steel Base Check the brac...

Assemble the Pump Head with the Bracket/Motor Assembly Instructions Step 1 - Place the Motor vertically on a piece of clean cloth on your workbench. The Motor should be rotated so that the Base should...